Matrix Appliances MHN100FR Manual

1Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HYT : 01949 862 012 F : 01949 862 0

10Fitting the HobUnpacking the hob:Take care not to lose or mishandle any parts.Fitting position of the hob:This appliance must be installed a minimum

11How to install the hob:Overall dimensions of the hob:Width: 580 mm Depth: 510 mmWorktop cut-out dimensions:Width: 560 mm Depth: 490 mm1. Make

12Power configurationThis hob can be connected to a 13, 16, 25 or 32amp supply and configured to work on any of these power settings. If the hob is conn

13Mains Electricity ConnectionWarning! this appliance must be earthedWe recommend that the appliance is connected by a qualified electrician, who is a

14

15

16Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HYT : 01949 862 012 F : 01949 862

2ImportantThe CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note tha

3• Always use appropriate cookware. • Do not cook unopened tins of food directly on the hob.• Never put cooking foil or plastic materials on th

4Using your Hob The table below offers guidance as to what each power level is for.Power level Type of cooking0 Switched off1/2 For melting (butter/ch

5Using your HobTo switch the hob onTo switch the power on, touch and hold the for approximately two seconds. The hob will beep and all four zone di

6ChildlockThe hob is equipped with a childlock to lock the controls. This can be used when the hob is off or during cooking. To switch on the childl

7Efficient Use of your HobThe hob is equipped with zones of different sizes, designed to accommodate most shapes and sizes of pan. For best results, on

8Care and MaintenanceAlways disconnect the appliance from the power supply before undertaking any cleaning or maintenance.Important: • Steam cleaner

9You observe that Possible Causes What should you do?The display shows a series of digits and symbols on first connectionWorking normallyNothing, the h